Windsor Scissor Lift Certification

Windsor Scissor Lift Certification - Lots of worksites and tradespeople like masons, iron workers and welders utilize scissor lift platforms to help them reach elevated work areas. The operation of a scissor lift is normally secondary to their trade. Thus, it is vital that all operators of these platforms be correctly trained and licensed. Industry, lift manufacturers and regulators work together to ensure that operators are trained in the safe utilization of work platforms.

Scissor lift work platforms are likewise called manlifts or AWPs. These work machines are somewhat simple to operate and provide a stable work surroundings, nonetheless they do have dangers as they lift people to heights. The following are several important safety issues common to AWPs:

To be able to protect people working around work platforms from accidental power discharge due to close working proximities to wires and power lines, there is a minimum safe approach distance (MSAD). Voltage can arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

To be able to ensure maximum stability, caution should be taken when lowering the work platform. Moving the load towards the turntable, the boom should be retracted. This would help maintain stability during lowering of the platform.

The rules about tie offs do not mandate individuals working on a scissor lift to tie themselves off. Several organizations will however, require their workers to tie off in their employer guidelines, local regulations or job-specific risk assessment. The manufacturer-provided anchorage is the only safe anchorage wherein lanyard and harness combinations must be connected.

It is important to observe and not exceed the maximum slope rating. The grade can be measured by laying a board on the slope or by laying a straight edge. A carpenter's level can then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, you could determine the percent slope.

To be able to determine whether the unit is mechanically safe, a regular walk-around check should be carried out. Work site assessments are also necessary to make sure that the work place is safe. This is essential especially on changing construction locations due to the chance of obstacles, contact with power lines and unimproved surfaces. A function test has to be done. If the unit is utilized safely and properly and right shutdown procedures are followed, the risks of incident are greatly reduced.

Click to Download the pdf